Samson 34 (Cape Island Style)

• Solid fiberglass hull
• UV resistant, high gloss ISO gelcoat
• Coloured waterline
• Hydrodynamic, tapered stern post
• 5’ Wheelhouse built with fir plywood to customer spec.
• All plywood glassed inside and out with gel coat finish
• 4 x 4 wheelhouse beams stained and varnished
• PVC grab rails
• Stainless steel bow cleat, stern and bow staples
• 6- 4" stainless steel scuppers in recessed pockets
• All sliding and folding doors on Teflon tracks
• Drain plug in keel
• Heavy duty PVC rub rail
• 9 fixed PVC windows

• Deck hatches are aluminum set in Stainless Steel frames, common size 24” x 24”, any size available.
• Bomar Hatch in Cuddy 24 x 24

Straight shaft assembly complete with:

• 13' X 316 SS shaft comes with brass nut
• Stainless Steel shaft log with cutlass bearings and inside box
• 4 bolt heavy duty steady bearing
• Shaft coupling
• Anodes
• Installation
• Propeller blade 28” – 30” Diameter

Single station hydraulic steering complete with:

• Hydraulic pump comes with pulley, belt and mounting bracket
• Steering unit comes with 15" Stainless Steel steering wheel, Stainless Steel spindle and mounting plate
• Dual ram steering unit with nitrated steel piston shafts
• Hydraulic hoses, fittings
• 2" Stainless Steel rudder stock and 28" X 26"X 1/4" SS rudder with support wings
• Installation

2 Stainless Steel fuel tanks constructed with 11-gauge 2B-finish plate:

• 2" fill lines and 2" Stainless Steel deck fills
• 1" vent lines
• 3/4" suction hose (hydraulic hose) from one tank
• shut off valve
• inter connecting line (3/4" hydraulic hose )
• 3/8" return line to one tank
• installation
• 2 tank whistlers
• 200 gal

• Jabsco 1 ½" 3-way ball valve
• bronze fittings
• 1 ½" thru hull and sea cock
• reinforced PVC hoses
• Wash down hose nozzle
• Installation

• 11 circuit load center
• Group 8D cranking battery
• Battery box #4 electrical mains, #2/0 starter cables
• 4 running lights port starboard, stern, masthead, + anchor light set
• Stainless Steel dome lights
• Pantograph windshield wipers - heavy duty
• Rule 2000 GPH bilge pump 3-way switch float hose

• Installation, alignment and bolting
• Solid fibreglass engine beds
• 2 X 1 ½” thru hulls, seacocks, bronze fittings, hoses, heavy duty clamp, strainer
• Kobelt controls and cables twin
• 6” wet exhaust thru stern / no muffler

• Table with benches
• Top and bottom bunks
• Cupboard and counter top
• Manual marine toilet with brass fittings, thru hull, including enclosure
• 3-outlet engine heated heater

• Stainless Steel Bow rail
• Galvanized Steel Prop cage
• Cross tree / radar arch FRP
• Engine
• Hydraulics 12” lobster package with Direct Drive and Aluminum Mast
• Electronics
• Sliding windows PVC
• Builders Risk
• Lettering